Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ab
3/2 sov means 3 port 2 position(open,close)
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
why orfice is not used for main steam flow calculation
In turbine what does term CDP, NI, NH, HSSOC means.
selection criteria of control valve? and selection criteria of actuator explain in brief?
What is solenoid valve? Where it is used?
what is instrument philosophy
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
is there any digitel grevity meter availaible in the market by which we can measure specific gravity of a battery?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
What is the use of single seated valve?
What are de-saturators?
How to calculate mmwc values into tonnes?
Which is the best field foundation bus. ( FF ) Yokogawa, Honeywell or others ?
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
How the warning lamp of a charging-system is activated ?
What do you know about gail?
