Can we use pure oxygen in IC engines instead of air??
what would be the advantages and disadvantages of using
it?? Have any steps been taken about this??
Answer Posted / sai theja
tremendous combustion takes place if we use oxygen which may cause structural damage to engine block.that's why the presence of mixture of gases in air provides the controlled combustion of the charge
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
which fit is this 177-S6?
HI, I am Darshan S D completed BE in Mechanical & also completed my MBA in Finance & Marketing.Presently i am working in Geodis Global Solutions which gives support to the IBM, as a logistics coordinator. i have a plan to do SAP but confused which Specilisation to do ie whether in Finance or Material management. Also scared whether it is right for me to do that, is that will help me in getting good job. what is the future opportunity and present job position in the market.... pld kindly help me to know...
What is a bearing?
If any changes done in the process of production what that is called.
Draw the flow of F.O. diagram from service tank to Main Engine?
. how will effect of water injection on turbine load and corresponding MW output(not water washing)
wt is MAG weld? wr it is specifically used and reason for it .
Where can you find space heater lam p and what is its purpose?
why we transfer FA(full arc) to PA(partial arc) in steam turbine at specified load?
How do you repair a hydraulic jack?
What safety device will activate to stop the compressor in the refrigeration system
Is there a lower limit to the gland surface finish for static O-rings, gaseous system? surface finish table lists 0.41-0.81 micro-meters for static gaseous systems. What is the drawback of using a smoother surface finish lower than 0.41?
What s gland sealing steam?
What causes crankcase explosion?
what is an intensifier?