Interested to Buy Any Domain ? << Click Here >> for more details...
If single phase voltage level is 230V than why three phase
voltage level is not 660V ?, but it is only 440V.
- 16 Answers
- 75612 Views
- BSNL, DOS, EFS, HMT, L&T, TCS, ThyssenKrupp, I also Faced
- E-Mail Answers
Answer Posted / engr.waseem
we take voltage between two phases in 3 phase system.so in three phase system voltage between two phases or simply we can say line voltage is 380 V calculated by following formula:
line voltage=square root of 3*220(phase voltage)
=380V
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
why servomotor motor? where i apply for best output?
do we use neutral grounding for resistive balanced load? if we use what happen?
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
If rotor works in clock wise what happens
How many double suspension hardware fittings are required on a double circuit transmission tower?
while doing high potential for 11KV 3 core cable how much leakage current will obtain?, what will be acceptance value?
what is the easiest method of short circuit current calculation ? pls. derive with a mathematical example in real life application.
how much flux density of CRNO core
what is the relation between knowing of the distance between power transformer and the capacitor feeder in case of parallel operation
if negative of DC supply used and positive is grounded through EGB, and if ELCB used in the system then is it sense the positive volatge and get tripped is it possible?
What is the general power consumption rating of CPU CRT type and Flat type, Monitor,Printer, projector, Scanner?
Make a list observation on Transformer?
what is the difference between directional & non directional earth fault with example please explain.
What is difference between unity power factor wattmeter and upper power factor wattmeter? In short circuit test of transformer the wattmeter used is unity power factor type or upper power factor type wattmeter?
