Interested to Buy Any Domain ? << Click Here >> for more details...
purpose of breaker contact multiplication relay?
- 5 Answers
- 25662 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / sourav pramanik
contact multiplication relay are used for incresing contact...let there are so many on off switch ,alarm are to be activated..but main relay contacts are very less..so to increase contact we use cmr.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
What is method of calculating the fault current for a MDB, 50KW, 3PH, 415V, 50HZ?
how to carried out tan delta test in 11 KV alternator ?
in shunt clippers why a resistor is used in sereis with the input
How can I known multiplying factor .without multiplying table
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
What are the types of control system?
How shall i select the value of capacitor or inductor in a system?
in the case of 6.6kv motor starter combination contain fuses on it VCB. but in 11KV motor starter combination Fuses are not using in it's VCB why?
what are the different sizes of U.G. cable & where these cabl;es are used according to voltage ..
What descriptive information does the NEC require to be marked on all conductors?
Difference between low impedance and high impedance Restricted Earth Fault
is the value of inductance depends upon the value of thitha in doubly excited machine??
what is the min and max ohmic resistance for the earthing rod installed for lighting poles for street light network
We have two parts in generator, electrical & mechanical. how it works?
