Interested to Buy Any Domain ? << Click Here >> for more details...
what will happen if the input of a transformer is dc?
- 10 Answers
- 11510 Views
- Hindalco, I also Faced
- E-Mail Answers
Answer Posted / swapnesh chhand
if the in put of a transformer is DC then ,no change of current with respective time steady current will flow due to which change in magnetic flux will not take place & induced emf will not be produce & therefore the transformer
will not work
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why do we apply both Differential and REF (HV and LV) protection schemes on YNyn configuration of a transformer?
What is the significance of integral controller and derivative controller in a pid controller?
When calculation of fault current and fault Kva is to be done,why always we use per unit value and why we consider the base kva?
Why does inductive loads consume KVARs?
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
how can we change the polarity of Alternating current rapidly? how frequency of ac can be controlled and changed easily?
WHAT WOULD BE THE FORMULA OF WIRE GAUGE FOR A FULL LOAD CURRENT
If mutual flux is 1.2wb & power factor is 0.8 lag , then what is the Useful flux of a transformer?
difference between a diode and thyristor?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
what is the saturation point of crgo lamination.
what is the purpose that we use PLC system in power system
Batteries. What is the difference between Lead and Nickel batteries ?
What are capacitive,resistive,inductive surge absorbation? What is ferranti surge absorber? What is lagrangian cost? What is Px operator?
If VFD is On but no starting commond on it. so how many outpout voltages of VFD
