Answer Posted / tony
Transformer load depends on Voltage and current not on power factor or phase angle between voltage and current so it is rated in VA .So we used KVA ; total power for a transformer can supply.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how we start 40w tube light with 4 diodes,2capacitors,1 choke and without starter.(a product avilable in market which lights burnt tube lights also)
Why Neutral Isolation is required?
what is circuit breaker in transfomer and where it used
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
What do you mean by passive circuit elements and why these are called passive?
Safety of on line ups
i have to install a HT panel, what components, I have to use in this and what will the diagram of that diagram,please tell me each and everything.
How can we calculate the motor frame sizes?
if we apply 1000ADC instead of 100ADC or We apply 50ADC instead of 100ADC,What will be happened in the test result value.Pl explain
Define settling time.
How to control motor gearbox speed and friquency? If length of cable and dia given, how to measure the voltage drop?
what is inverter and converter
What is the test block protection relay if any body know plz explained
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
what kn of disc is used in 33kv,132kv,220kv,400kv,800kv transmission line
