Answer Posted / engr. karuppiah mariappan
The UPS is uninterrupted power supply equipment. It contains the following
1. Rectifier - It will conver the AC power to DC
2. Battery Bank – It will store the charge and deliver the power to the inverter
3. DC - DC Converter – It will increase the DC voltage ( Like DC Booster)
4. Inverter - It will convert the DC Power to AC power and feed to the load
5. Static by pass switch – Incase any problem in the above it will divert the power from mains power supply to load
6. Manual by pass switch – It will use to take any maintenance or replacement of any modules / PCBs
5. Transient voltage and surge supression filter circuit – It will filter the unwanted surge / Harmonics.
| Is This Answer Correct ? | 18 Yes | 1 No |
Post New Answer View All Answers
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
What is the difference between isolators and electrical circuit breakers?
why do we lay up the core of a cable?
Why is back emf used for a DC motor? Highlight its significance.
in dc shunt motor if field winding is shorted then
what are the range of memory address in plc for L&T lx7 4A
advantages & disadvantages of Lagging and leading power factor .
Air circuit breaker safety
give single line diagram of D.G distribution form alternator to main L.T panel?
Installation resistance for whole installation of 16 kva & 25 KVA DTRA a) Between each conductor b) between conductor to earth c) installation resistance for each apparatus, each conductor to earth d) earth resistance for the system of earthing
state the working of discharge lamp?
what is resver in electrical enginnering with answer
How to calculate the size of earth cable to earth the neutral of UPS ?
when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
What is true sine wave or pure sine wave inverter?? Is it sine wave or step wave?? If it is step wave, waves with how much step is considered as pure sine wave? Is it possible to produce pure sinewave using power electronics?