In my home i am getting too much electricity bill (more than 4000) but I am very much sure that we are not consuming that much. How i can check this ?
Answer Posted / bunty
Apply for Meter Testing & if your Meter is new then first check your home wiring.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
what is an unbalance in acircuit? in a three phase 3wire circuit how an unbalance will come? in a three phase four wire system how an un balance is coming?
what is the voltage rating of chiller unit sensors
What will be the impact on motor performance if a LT motor is rewound with changed motor winding data as given below:- Original winding data: total 04 wires = 02 wires of 17 SWG + 02 wires of 16.5 SWG. Changed Winding data: total 03 wires of 15.5 SWG wire size Motor rating: 160KW, 740RPM, 415V, ID FAN application. Normal Running Current = 95% of FL Current.
HOW TO CALLICULATE RESITENCE,REACTANCE AND IMPEDENCE VOLTGE OF TRANSFORMER 13.33 KVA 144/240 VOLTS 93/56 A WITH FORMULA
I'm looking for a softcopy manual set for a Credence ASL- 3000. Anyone know where I can get it?
Why the frequency of ac in india is 50 hz but in some other countries it is 60 hz.
how harmonics generated in induction furnance? how minimise it?
Mention the disadvantages of low power factor?
What are the criteria shall be considers for sizing Fuse and MCB? If the rated current is 10Amps what should be the fuse size / MCB Size?
What is difference between start imitation and start interlock for 3 phase motor protection ?
Is there any abbrevation for STUB in Stub bus protection
what is basic difference betmeen normal & flame proof motor??
In electrical locomotive engines, the DC series motors is being used as traction motor. But in new engines like in WAP7 & WAG9 the 3-phase squiral cage induction motors has replaced them. So can someone tell me the advantages of induction motor over dc seris motor in engines points of view....???
2. What are the parameters of EHT sub-station?