Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between fiber optic cable & Ethernet cable
- 2 Answers
- 5471 Views
- BEMCO, CCC, Pidilite, I also Faced
- E-Mail Answers
Answer Posted / g.dhinesh kumar jj
FOC - Fibre Optic Cable is used for Long Distance Communication. (Example- Communication Between DCS controller and any third party device. DCS Controller in Control room and the WTP PLC Panel) so here it is used.
ETHERNET - is used inside the control room, in between the controller and Ethernet switches.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
What is the purpose of the analyzer in petrochemical plant?
Hook up resistance decade box to temp.transmitter.
how to calculate the total flow in square root
Where is wet leg is used?
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
What are different types of orifice plates? State their uses.
how can we tune a PID. If it is by zeiger nichols method..please explain briefly with help of an example.
Instrument QA/Qc what is the project quality plan?conduit inspection RFI. which documents attache with package?
Somebody tell me in what way i need to prepare for csio pgrpe(adv instrum eng)interview?what all the quest can i expect?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V
we have a s-5 simense plc having op7 .recently on op7 showing error 1.plc not present 2. DB error frequently. can u have any solution . please send me.
give eg of how I/P is used in control loops
Please asked me How calculate DCS controller memory.
