Interested to Buy Any Domain ? << Click Here >> for more details...
what is vibration sensor working principal and how many types its has??
- 5 Answers
- 7326 Views
- I also Faced
- E-Mail Answers
Answer Posted / ghanshyam khatri
two types one contect type onether is non contect type
contect type is eddycurrent based and noncontect type is piezo electric. in non contect type we have to set gap voltage and output is volts and piezo type only output is 4 -20mA
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
How to decrease opening & closing time of on/off valve?
How digital input and digital output 's are working in dcs
why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??
What are the uses of orifice plates?
how pressure transmitter work, what is its principal to measure and how its generate signal. for pressure transmitterinstallation which precautions must be taken ??
what are the values of fuel flow rate in various places in boiler.
how to calibrate steam control valve in steam turbine
what do u mean by compensation n pid tunning?in pid tunning what you tunned?is it possible 2 tune p i d
What you mean by multi stage control vavles?
How servomotor controls throttle valve of TURBINE?
How we calculate orifice plat size???
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
Can anybody please let me know Orifice plate sizing calculation formula and step by step procedure
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
