Interested to Buy Any Domain ? << Click Here >> for more details...
I have transmitter of range -20 to -5 kpa.if it is possible to zero trim with atmospheric pressure,means HP and lp having no pressure...what will get after zero trim and it is the right way.....plz give me reply ....
- 3 Answers
- 5124 Views
- KOC, I also Faced
- E-Mail Answers
Answer Posted / ab
Simulate -20kpa before doing zero adjust......
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
What is force balance principle?
What is the basic difference between Modbus and CAN Open Protocols
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
How a conductivity sensor & analyzer work at boiler, whats the principle & science is beyond this,How conductivity sensor sence & convert signal & move toward analyzer & analyzer show reading in percent? also what is temperature compensate option in conductivity analyzer
Calibration procedure for water rotameters
please can any one tell me clearly about pid tuning i am confusing about this .how to tune pid easly?
How earthing can be checked????
send me HPCL paper
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
Explain operation of Haskel pump.
What are the application of bernoulli’s theorem?
I installed the smartplant instrument v8, but can not be opened, that always said: "INTools 2007 hardlock no found". So Could you help me how to do for that?
What is modbus?
what is the imbustion control loop
