why is power supplied in 3 phase only? why not in 2 or 4
phases?
- 11 Answers
- 30926 Views
- I also Faced
- E-Mail Answers
Answer Posted / sanjeev
as the first person said in case of three phase system we can get a rotating magnetic field where the phases are 120 degree phase apart. But if we use 5 phase we can get the phases apart from each other is 360/5=72 degree.
as we all know the sine wave is maximum at 90 degree.
So in case of 5 phase system we cannot get the sine wave at peak amplitude.
In case of three phase system one of the three phases always at peak position so we can get an uniform uninterrupted optimum service in case of three phase system.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
Difference between a pilot wire and a normal conductor?
if sf6 gas low in gis what will happen
Why does increasing the magnetic flux in the main field of a d.c motor cause the armature current to reduce??
How to select a cable size for particular load?
what is the write prosidure of stringing of 8meter pcc pole.
in single phase converter, the no.of scr's conducting during overlap a)1 b)2 c)3 d)4
How does "OUT OF STEP" relay ,for Synchronous motor protection, work?
What is the Surge for 1.1 Phase Induction Motor(For Eg.1Hp) 2.3 Phase Induction Motor(For Eg.1Hp) 3.AirConditioner(For Eg 1Ton) 4.Refrigerator(For Eg 180Ltr or 160kW) 5.Induction Cooker 4. Ceiling Fan
Why do power lines not short out when they fall into water?
volts=230 c=10mf a=??
I have a small system with two motors that are running on 380 vac, 60 hz. These motors are expensive and I usally get them from Brazil. I am adding another motor to the system, but I want to purchase a 480 vac, 60 hz motor to use. It will be on a VFD that is rated fro 380 thru 480. Is this posible and will I have to use a larger motor and derate it?
Basic motor transformer generator
Saving in copper achieved by converting a 2 winding transformer in to an auto transformer is determined by A voltage transformation ratio B load on secondary C quality of core material D size of transformer core
Can you any one explain application of buccholz relay operation and pressure relif device operation of power transformer
Is single load(eg: three phase motor) having all the components like positive,negative,zero sequence components during fault condition?
