Interested to Buy Any Domain ? << Click Here >> for more details...
In a selection of suitable heating equipment for drying of crystals of biochemical, the one of the lowest current consumption will be chosen for safety consideration. Selection is available : (A) 120 V microwave oven 1800 W. (B) 240 V conventional oven 11000 W. Which one should be chosen and why?
- 1 Answers
- 2441 Views
- I also Faced
- E-Mail Answers
Answer Posted / kang chuen tat (malaysia - pen
For (A), AMPS = WATTS / VOLTS = 1800 / 120 = 15. For (B), AMPS = 11000 / 240 = 45.83. Dryer (A) should be chosen as less current is consumed. The answer is given by Kang Chuen Tat; PO Box 6263, Dandenong, Victoria VIC 3175, Australia; SMS 61405421706; chuentat@hotmail.com; http://kangchuentat.wordpress.com.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the advantages of using a ball mill over other conventional methods of crushing?
Explain the different ways in which solids can be blended?
Explain what information is needed to specify a mixer?
solution =2oolitre ,solute =Polyelectrolyte,Solution=water ,we have to prepare 1% solution.how much solute And Solvent?
Can you pls tell me how to calculate the amphere rating of cable in case of three phase supply but all load is single phase
What could be a possible cause for sudden foaming in a cooling tower?
Are some heat transfer services more prone to tube vibration that others for a shell and tube exchanger?
What effect does choking a vertical thermosiphon have on the heat transfer rate?
What is a common source of error in determining the percent spent caustic in refinery applications?
How can I treat a waste stream containing both hexavalent chromium and arsenic?
What is the significance of the minimum flow required by a pump?
What are the criteria’s involved in choosing mass balances for components?
What does the catalytic converter on an automobile really do?
What is a good source of equations for calculating discharge flowrates from accidental releases?
Is there any way to remove residual product left in pipes after a batch operation?
