Answer Posted / afsar mumtaz
to measure process variables like ,temp,pressure,flow,level and distance.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail
What are different types of orifice plates? State their uses.
any body please send me the old question papers of ongc test.
What is the use of temperature compensation?
how to calibrate mass flow meter (Coriolis)? Example calibration range: 0 to 2500 kg/hr line size 3" fluid: Etheline glycol (MEG)
how is work pressure switch& level switch?what is the principle of this?
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
Why plc require in analog input 4-20amp & 0-10 volt?
Can I calibrate the Electromagnetic Flow Meter on line and How.
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
How the sizing of the analog signal cable is calculate?
Isometric drawings are generated during _________________ phase of a project
Working principle of magnetic flow meter ......and calibration procedure of e+h magnetic flowmeter...
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
