Answer Posted / krishna das
power factor=true power/apparent power or power factor=V.I.cosfie
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What is an alternator impedance value?
In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem
WHAT IS DEAD END IN PROTECTION?
How can calculate the rating of a servo stabilizer for given a specific load
After taking shutdown of 11kv feeder, if you see 5kv by phasing stick in the cable side, is it possible to close earth switch in cable.
Please tell me the formulaes while designing a substation for power Calculations in designing a 33 KV Substation?????
How many types of protection relays are there based on the characteristic?
Explain Need of a starter in a dc motor.? Also explain any two starting and speed control method of dc motor?
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
what is the minimum pay scale for electrical engineer (building construction)in kuwait? plz revert back with yrs of experience & pay scale respectively.
What is the effect of atmospheric pressure & Temp; on efficiency of motor? Why NGR(Neutral Grounding Resistor) is used in 132/11 KV Transformer & how? What is the use of Auto T/F in Grid Station?
How stabilizer works??
how line turns ratio changes in 3 phase with change in connection
Draw transformer phasor diagram.(full load,no load)
hi i will D.E.E.E.is completed pls send rrb diploma old qustion papaer sent in my e mail. i.d.
