Answer Posted / asif
Function Test is to carried out the test for the devices wherether it is functioning properly or not as per the data sheet . Usually in Instrumentation, it is carried out for pressure switch, flow switches etc.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
in valve is constructed as per SME B 16.34, then which standard is used for fire testing of valve?.
I want to apply for the universities in US,but i got the GRE score of (650+300=950)TOEFL 69/120.Is this score sufficient for applying universities please i am married i need to go to US because my husband didn't get H1 yet.please send me suggestion
Calibration procedure for water rotameters
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
I want to know about DDCMIS in detail ? please explain it. Also give name of reference books in which it is explained in detail in very simple manner.
how pressure transmitter work, what is its principal to measure and how its generate signal. for pressure transmitterinstallation which precautions must be taken ??
can anyone tell me about the basic concepts to consider before to start a PLC panel wiring
2. What is ultrasonic flowmeter?
when a magnet is heated?
Emergency Shutdown Systems/ Plant Shutdown System.
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
what is maxdna ?. explain about the software details.
How do you identify between actual alarm and false alarm in a Temperature Transmitter in SCADA based Control System
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
what is cold loop? difference between hot and cold loop?
