Interested to Buy Any Domain ? << Click Here >> for more details...
why electric shock due to dc is dangerous than that of ac
- 44 Answers
- 66936 Views
- I also Faced
- E-Mail Answers
Answer Posted / rennaga
Hello guys,
I have not much knowledge to judge on your answers but I have also come with an evidence that DC current is more hazardous than that of AC. Reason- I have taken shock myself for a second(time) from both AC and DV current with a frequency of 50-60hz while experimenting the effect of the current.
1) AC- The shock was higher from my hand to every corner of my body but I felt relaxed after a min or two. And nothing else occurred when the current flows is lost.
2) DC- I took the shock the same time (a second) as AC and the current was less powerful than that of AC current. But not forgetting, the hand which I touched the DC current during my experiment is having a muscle cramp seldom up-to-the-minute.
So my friends, I can't assure which of the current is more dangerous but I can assure as both are dangerous to death or life with dead body part(s) is worst.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Define the term factor of inertia.
How LT megger works ?
How to calculate Air conditioning capacity for a telecom BTS shelter?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.
how to test power transformer.YNd11
What range of speed can you get with the field control method of speed control of d.c. Shunt motor?
What is dielectric loss?
Explain and give me an example of a time when you had to explain some new procedures to your co-workers for quality service delivery, how did you go about it?
WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.
Type of motor stater detail and working detail
working principle a.v.r. ?
What Normal(Tangent) towers and Tension(Cut-point) Towers?
Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???
What is the function of electron gun assembly used in crt?
