why not maintain Ph 7.0 in Boiler because 7 Ph is not acidic and not basic.
- 4 Answers
- 7251 Views
- Atlas Power, I also Faced
- E-Mail Answers
Answer Posted / alok bhattacharya
We need to mix scavenger in feed water in order to make it oxygen free which helps boiler from corrosion. Phosphate dozing is primarily done for this purpose and this raises PH value and usually maintained around 9. Moreover phosphate dozing helps to make magnetite layer which inhibit corrosion.
Acidic water is prohibitive in boiler for above reason, i.e.
Ph below 7.
Thanks
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
some one can tell me how residual type excitation is provided through transformers to an AC generator without any battery or PMG&excitor
How to calculate boiler capacity? I have 1 Autoclave, Which has to use for AAC block. Dimension for this Autoclave is - 13 Meter Length & 2.2 Meter Diameter.
What is difference between secondary Air & Tertiary Air and Their use.?
dear sir i have completed one year post diploma certificate in thermal power engineering from national power training institute durgapur ...plz suggest me for power sector job
our 125 kva DG does not start in AUTO mode works normally in MANUAL mode please give me a solution.....
what is the trip circuit supervision in an electrical meaning?
What is LB-SR.
can u please tell me how to calculate the concrete quantity for a under reamed pile? r=300mm,depth=3m for a cylinder and for bulb l=.750mm,width=.525
DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.
What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?
what is the difference between compensated & normal drum level in boiler drum?
By any way can we increase the B check hours from 300 to 500
why airtel use + 24 volts and other operators use -48 volt
We have Demin Closed cooling water system with expansion tank for cooling oil system. Expansion tank having N2 bladder. Whenever N2 bladder bursts out, Closed cooling water circuit pressure drops and make-up happening, eventhough there is no leaks. And how Circuit pressure drops?
im try to calculating seawater flow required for SW-FGD system. I need a guide, equation or method to do it, can some one help me! Thanks very much
