Interested to Buy Any Domain ? << Click Here >> for more details...
what is difference between sub-station and switch yard.
- 16 Answers
- 107297 Views
- Bhel, Ravate, I also Faced
- E-Mail Answers
Answer Posted / shubham batham
A switchyard is where the power is maintained at same level without change of voltage after generating transformer the power is feed to the switchyard with the help of conductor bar.
A substation is that where the voltage level is maintain both of condition step up or step down as per requirement400/220/132/11 kV substation
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
What is T’Q and X’Q and X’D ? and what is saturated as well as unsaturated ?
give some advantages and disadvantages of combiniing the session, presentation, and application layer in the osi model into one single application layer in the internet model
Which type of air compressor is used now a days in the market. Keeping in mind of energy efficiency and maintenance points. Relevant documents may also be sent on mentioned email ids.
WHICH SIZE A.B.CABLE IS USED FOR 11KV.
what is 30-phase of transformer
What does the kvar means?
where solid grounding and where grounding through ngr done and why?
How is the gain affected by the introduction of feedback in a control system.
whatis the commertial spec. of distribution boards ?
What is systematic error?
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
11kV capacitor bank of rating 2.4KVAR, is charged with protective relays of only over current & Earth fault &.......without Over Voltage, Under Voltage & Neutral Displacement Relay. Is it advisable??
63MVA,220KV/6.9KV Transformer LV side neutral is connected to Earth pit through NGR. Whether this earth pit required to connect with near by below grouding earth mat or it is to be kept separate?
What is a difference between indoor transformer and outdoor transformer of same rating
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?
