Answer Posted / deepak mishra
AMF(Automated Mains Failure) normally is called panel.When main fail our micro controller based controller(PACE ATS) sense this and gives command to DG start through Relay (PACE DG 99).In this time also sense fuel level,oil presser,dg Battery voltage,dg RPM,Mains Voltage,Dg voltage,Battery Bank voltage, Dg run Time,Temp.,load on EB, laod on DG.
when mains back again the controller will sense and gives command for DG stop automatically and also stop our set time in controller.
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
What is 100% protection of generator? Why 100% is not used but 95% is generally used?
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
how we test a 3 phase motor on single phase supply....? HOW WE RUN A 3 PHASE MOTOR ON SNIGLE PHASE. supply for testing..? how we verify of a 3 phase motors 6 wire & name thame a1/a2/a3..b1/b2/b3 and c1/c2/c3 for connecting star delta starter ........i have only 1 phase supply ? help forum..........
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
How I calculate the ELCB for circuit breakers?
how to convert lv line to hv line and viseversa, any losses will occur during this process
IN 1000kva transformer where the oil and winding temperature sensors is connected
How o select the electrical fuse?.What are its characteristics.How to select the material od fuse?
ELECTRICAL ENGINEER TEST IN FEWA ANY ONE HAVE KNOWLEDGE ABOUT THIS?????????
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating
What is the formula to calculate the rating of power cable for three phase current.
salam,hi, i need to know what the spesification of 300amp msb...
why is using sensor?what is differece between photoelectric and proxmitty?
why output is out of phase in case of common emitter?
I want definition for ABT Meter (Availability Based tariff) ?
