Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / raise
Adsorption
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the difference between chromatographic purity and related substances?
As per ICH related substances stability trend limit from initial to shelf life
How to calculation of residual solvent methanol (3000 ppm) standard solution, and how many quantity used of test sample
What is shaking level in GC?
How we choose the mobile phase for method development.?
Why irmoisture balance is used for corrugated box moisture testing
I have compare C2H2-air and C2H2-N2O flame AAS on determination calcium. Both use same range of std to plot calibration curve. (2-6ppm) When i measure the sample with phosphate, KCl and LaCl, C2H2-N2O flame give false positive result, around 0.5ppm. When i measure the sample with phosphste, KCl and EDTA. C2H2-N2O flame also give 0.5ppm false positive. But both above mentioned sample would not give false positive when measured by C2H2-air flame. What is the reason?
what is classification of elemental impurities? what is risk assement in elemental impurities?
Describe your field experience sample type collected,sample techniques,field measurements taken and equipment used?
How to set analyticl specification for combination products?
how to decide for one product require water content or LOD?
if your product is soluble in 0.1n hcl and water then which you choose as media from these 2 media?
My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards
give clarity of linearity and range in method validation
How can we calculate offset value pH measurment
