Interested to Buy Any Domain ? << Click Here >> for more details...
How would you supply a single house hold load from a 3-phase
supply coming out of a sub-station?
- 4 Answers
- 8647 Views
- Power Grid, I also Faced
- E-Mail Answers
Answer Posted / naresh desetti
to use a 11kv by 440 step down t/f after we will get a 440 volts with neutral point
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Operation carried out in thermal power stations?
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
How can we decide cable size from HT panel to Transformer? Please give you reply with some examples.
Can you explain about pole discrepancy scheme
why we use condenser in the thermal power plant, althrough the same vapour will be again heated
what is the circutor?why we use it ?
I want single line diagram for AMF & DG syncronizing panel
Batteries used for electrical energy storage are a. Laclanche cells b. Edison cells c. Lead acid cells d.any of the above
i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.
How can we calculate the motor frame sizes?
What is stepper motor?
how can you calculate fault level ?
What is routh hurwitz stability criterion?
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
I need a formula to calculate the size of cable as per load but in the terms of length. Please Reply me as i search lot of sites but i did not get the answer.
