Interested to Buy Any Domain ? << Click Here >> for more details...
What is Difference Between Induction Motor & Servo Motor
- 31 Answers
- 103976 Views
- Jindal, Kirloskar, KTTM, Star Technocrates, Toyota, I also Faced
- E-Mail Answers
Answer Posted / asanya
Main different between these two motor in induction motor we power source directly but in servo motor we pulse rating. That why its give more accuracy than induction motor
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to calculate slip ring induction motor stator and rotor currents??
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
When is lag lead compensator is required?
what is the major difference between LIBBP & HIBBP.. which one is most preferable..
what is the standard duration after failure EB power
How could I get a certificate of competency as Electrical Supervisor? I have completed By BTech in Electrical this year(2012) for VJTI Mumbai Maharashtra. Is it compulsory to be produced while joining?
How can we convert 11 kv to 440 volt without using transformer ?
Advantage of LT panel vs HT panel
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
how to carried out DAR test in 11 KV Alternator ?
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
Installation method of self treated earth electrode.
Why neutral point is consider as zero potential?
