Interested to Buy Any Domain ? << Click Here >> for more details...
What will happen if the rotor of an induction motor is fed
from a 3 phase supply and the stator short circuited ?
- 4 Answers
- 22220 Views
- I also Faced
- E-Mail Answers
Answer Posted / manas ghosh
It is
just like using the secondary of a transformer as primary. In this case the effective load depending on the value of rotational speed, which is r(1/s - 1) will be on the stator side. so, here 'r' is the actual stator resistance. Here supply side(rotor) acts as primary and stator acts as secondary. All other quantities like silp,Ns remain same but the definition of silp is not the same as in the case of stator side supply.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Under wat condition statcom operates as an inductor for the transmission line?
what is the use of Auto re-closer?
What is the technical difference between On delay timer and a Star delta timer?
why we dont prefer ac voltage controller instead dimmerstat [if both have same rating] for conducting experiments in laboratories?
What is the use of lag compensator?
In convertor can we use rectifier thyristor in place of invertor thyristor with explain.
What will happend if given Vfd out put to step up transformer
what is the k var ratting of 1250kva
what is formula for calculate thermal overload in new numiricalrelay( not in bimetal relay)?
What is the estimated total hydropower potential of india?
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
I want to merge a cable..in between two metering Cubicals which contains CT's and PT's and Energy meter..before taking merger..what are the common things required?
what is tri state logic gate
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
Meter p.t. ratio= 3×230/400 , c.t.ratio = 3×1 (2) A what is m.f.
