Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / himadri de
Neutral Grounding Resistor (NGR) is simple resistance connected in series between the neutral point of transformer and Earthing pit/point of neutral conductor.
NGR reduce the problems such as insulation breakdown caused by transient over voltage produce by arcing ground fault in underground system and damage to motors and switch gear caused by arcing in solidly grounded system.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
Could Please Explain briefly. Why used stabilizing resistance series with High impedance bus differential protection relay.
How many types of protection relays are there based on the characteristic?
What happen if 200 KVAR capacitor connected to power continuesly?
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
plz send me the placement interview question and answers of whizchip(technical and apttitude)..i have an interview in next.
Define active filter?
What is the working principle of MIG welding? and its out put Voltage?
why genarator genarating voltage 11 KV?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
1.4 What is meant by CT knee point voltage and how would you determine it
How vfd saving power.
all the technical question with answers pleas send your email id ramar_eee@yahoo.com
how to deside the capacity of chock for drive?
what is the practical application of full adder circuit?
What is meant by reverse polarity and how it can be fixed?
