Interested to Buy Any Domain ? << Click Here >> for more details...
Why we are using PLC instand of DCS in ESD System? can u
explain any one?
- 2 Answers
- 5448 Views
- I also Faced
- E-Mail Answers
Answer Posted / ajaya behera
PLC scan time is 0.1ms to 10ms
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
How to Calibrate Ultrasonic Level Transmitter in field
Dear Sir/Madam,im going to attend Hpcl written exams on feb 17th in instrumentation stream..can anyone send me the HPCL model papers and pattern of HPCL ....i ve not yet attended anything in HPCL...so i dont know how it comes...so just i need some model test papers and pattern ..pls help me friends...
what is the calibration procedure for transweigh make weigh feeder?
What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?
Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.
Draw a simple circuit for a well head control panel used to protect the well against fire, leak, blockage, ESD, & controls the operation of one downhole & one surface safety valve. Explain the operation and controls
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
What do you know about gail?
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
What are the interlocks we have to check during the start up of LP/HP compressor?
where are following valves are applicable to install. can any valve be installed any line. globe valve butterfly valve boll valve gate valve
I am manjunath having exp in maintenance of chemical plants,know i want to do a design course INTOOLS,after doing design course can we get jobs in design field.sinve i dont have design exp..
What is the use of GMV in turbine?
plz tell me clearly about PID.."when v have to change I value,D value,GAIN??
