Interested to Buy Any Domain ? << Click Here >> for more details...
The basis on which voltage selection of motor is done i.e. either HT or LT.
- 1 Answers
- 3333 Views
- DAE, I also Faced
- E-Mail Answers
Answer Posted / jithendra
depends upon the total KVA of plant
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
5- What is the task (function) of the excitation and isolation transformers in power plant? 6- What is the task (function) of LCI (A), LCI (B) and LCI (COS) in power plant? : LCI (A) and LCI(B) are load commutating inverter for generator turbine starting. , LCI (COS) is load commutating inverter change over switch
What is time invariant system?
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
If one lamp connects between two phases it will glow or not?
how to select the double earth conductor if 21A full load?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Where can i get practical knowledge of solar system?
what is the transformer turn ratio formula and give some examples?
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
in power generator normaly voltagr betwween esth to neutral is 0 but my work place generator show the volatge is 60v any body know why? thanks
What is the suitable transmission voltage?
What is the significance of integral controller and derivative controller in a pid controller?
Which type of air compressor is used now a days in the market. Keeping in mind of energy efficiency and maintenance points. Relevant documents may also be sent on mentioned email ids.
What is the relation between frequency and motor rpm?
How we can come to know the substation range,without go through any name plate ?
