Interested to Buy Any Domain ? << Click Here >> for more details...
Why shunt Generator is not recommended to start at ON LOAD condition???
- 3 Answers
- 4326 Views
- I also Faced
- E-Mail Answers
Answer Posted / nitin khatana
because it does n't build up full voltage and we don't want that consumer get directly 3v to 230v, by this the equipment get damaged.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking
Why AC current leads voltage in capacitor and how?
What is highest size of HT motor like 11 kv or 33 kv,and how to make it 750 rpm.i think the size will be very big.any idea ? pl. reply..
What is meant by earthhing of a magnetic flow meter and when to use empty pipe detection?
Please sent me some previous year question papers of BSNL-JTO telecom and RRB in ELectrical Engineering to varshashahi@yahoo.com
how to select the isolation tranformer for siemens 802dsl cnotroller
WHAT IS THE MEANING OG (li = 7 In)
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB to another Power DB?
What is Bolted fault?
please suggest some good universities with low cost iam in totally full confusion so please help me my profile gre 283 and ielts 5.5
WHAT IS MEANT BY INSULATION CLEARANCE IN VACCUM?
Why 9KV surge arrester having 7.65KV of MCOV?
what is solkor relay and which condition it will act?
What is the formula for calculating impedance of transformers connected parallel at fault level 50KA?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
