Interested to Buy Any Domain ? << Click Here >> for more details...
In a thermal power plant ID Fans running with full load but
boiler load is only 80 % give reason ?
- 9 Answers
- 20208 Views
- Essar, Prumatech, Tata Power, I also Faced
- E-Mail Answers
Answer Posted / y v subba rao
If the moisture content in fuel is more than designed fuel, id fans has to run at full rpm to sent out the additional water vapor produced from the additional moisture. In fact total flue gas quantity was increased
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what is restricted earth fault explain in details
Why superheated are started before I'd and rd fan?
procedure of how to generate power in solar plant.
why is the in steam turbine axial displacement of active side thrust pad is positive and non active side thrust pad is negative.
By any way can we increase the B check hours from 300 to 500
Looking for Bently Nevada surplus 3300/52-01-00-00 Reverse Rotation Monitor , 4 pieces.
what is the meaning of SST300 V56A in SIEMENS turbine
our 125 kva DG does not start in AUTO mode works normally in MANUAL mode please give me a solution.....
How to calculate power press toneage
How to calculate boiler capacity? I have 1 Autoclave, Which has to use for AAC block. Dimension for this Autoclave is - 13 Meter Length & 2.2 Meter Diameter.
DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.
dear sir i have completed one year post diploma certificate in thermal power engineering from national power training institute durgapur ...plz suggest me for power sector job
im try to calculating seawater flow required for SW-FGD system. I need a guide, equation or method to do it, can some one help me! Thanks very much
how to differentiate between "ALL fuel lost" and "All Fuel Lost" in Boiler MFT condition?
can dp type level transmitter work in under vaccum condition
