What is the meaning of key single line diagram?
Answer Posted / sai saran kandimalla
The details of power Evacuation and Distribution system in the power plant from the generator point till to each load centers at different voltage levels within the battery limit is described by Key Single Line Drawing. Key Single Line Drawing is the major drawing which serves as input drawing to many other drawings/documents.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
can we use NPT glands in LT panel
Why use the vcb at high transmission system ? Why can’t use acb?
How good are you in resolving the commercial issues to Employer's advantage?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
What cmos is and its benefits?
Please clarify 1. Icw: rated short circuit working withstand capacity 2. Icu: Rated ultimate breaking capacity 3. Ics: Rated service short circut withstand capacity 4. other specification of ACB
before synchronizing an alternator,power factor is leading ,why?
What is the role of Dedicated earthing in UPS System?
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
What are the three major categories of error?
if the load is 80 amp for main fuse and 100 amp for breaker so how can we calculate the cable size (cooper ) .
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
How can I known multiplying factor .without multiplying table
what should be the acceptrd value of winding resistance for 2.5MVA transformer
how to calculate vfd o/p voltage by frequency