Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ashok.nksn
need to fix the any electrical systems in suitable location co-ordinate with design dept& systems guide
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
what is the correct format to create a resume for interview??
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
What is phase cross over frequency?
Wind mill
why we use single core 630mm2 cable for transformer secondary side
how are reversing the direction of rotation of dc motor
Please send 110 kv sb station full single line drawing(sld)
what is the interrelation between voltage current torgue speed and magnetic flux in case of different types of electric motors
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
What descriptive information does the NEC require to be marked on all conductors?
Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.
What is meant by reverse polarity and how it can be fixed?
8. A DYNAMOMETER TYPE WATTMETER RESPONDS TO THE.......
why co incidence factor considered in transformer sizing?
