permissible compressive strength of m15 grade conc.
Answer Posted / avanish
15N/mm
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
PLS.......... ANY ONE CAN FORWARD ME PREVIOUS QUESTION PAPER hpcl civil engg
What are the advantages and disadvantages of lead products in construction?
what is meant by shear center?????
what s the standrd size of pvc fittings ,like elbow, bend,tee etc ? please explain with figure ?
quantity of material needed for rubble stone masonry for 1:4 and 1:6
Analyze the rate for 1st class brick work in superstructure with 1:6 cement sand mortar. Consider 1000 cu.ft quantity and work out the rate per cu.ft
What is M40 _ TOR - EQ and B.F.S
What are the govt approvals required for starting of power project. means from initial site grading and excavation work.exm. blasting in hard rock, deep excavation, cut off trees from site.
Describe the advantages and disadvantages of using plastic and timber fenders?
How do you maintain water pressure?
how much area can be platered by a mason for exterior
how to determine H- zone in a column? where it will occur?
1.Why we are preferring 43 grade cement than 53 grade cement. 2. Approximate cost difference between 43 and 53 grade cement. Thanks.
What is the unit standard weight,thicknessof C.I>Pipe of various Dia upto200 MM(as per IS1538)
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr