Interested to Buy Any Domain ? << Click Here >> for more details...
Two bulbs of 500w and 200w rated at 250 v will have resistance ratio as ?
- 2 Answers
- 15407 Views
- CGL, Dreamz Infra, Sunny Developers, I also Faced
- E-Mail Answers
Answer Posted / spark electricals
2:5
| Is This Answer Correct ? | 33 Yes | 4 No |
Post New Answer View All Answers
Has someone here done a sizing for a generator (3 phase), its for a pumping station. If you have an example for standby/duty and both running (I) star delta (ii) Soft Starter.
IN induction motor pf is increased using capacitors.what will be the effect on motor and system when very large capacitor is accidently installed and pf goes leading.
Q: How to calculate Transformer losses , tell us by Formula.
what is meant by k-rating in isolation transformer?what is k9, k14 stands for?
What do you mean by an instrument transformer?
If you have an earth with pilecap then your resistance is really low. why and how?
SUTIABLE FOR ohm's law super conductor
how to make an earthing certificate
What is the emf equation of a transformer?
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
i ha done my 10th with 71% ,ITI with 81% 11th with 75% 12th 43% apprentiship with 71% in SAT i secure 1390 ,TOEFL 27 i was refused four times and in all me interview visa officar told that i am not Qualify for study in USA but i completed my 12th yes i got low persentage in my 12th but i seen to much student they already got visa with them 3 or 4 backlocs so why they are refused me ?
How to calculate energy stored in a capacitance
what is ATS & RING MAIN UNIT in Distribution System?And its Function.
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
