Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / jayant mistri
At the star point vector sum of current is zero. If vector sum of current is not zero, deference of current will flow through star point.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
show the single line diagram of star delta starter with single phase preventer
Which is the largest hydropower station in the world?
What is the different between conventional MCC and intelligent MCC? Common controller or controller for each bucket
We have two APFC panels in same station. I need how to connect CT in two APFC panels.can we take one CT in series connection or two separate CTs.
We have 90mX100m hangar with 16 no.of supporting pillar. It is required to provide power supply on all pillars. what is suggested earthing scheme for hangars.
WHAT WOULD BE THE FORMULA OF WIRE GAUGE FOR A FULL LOAD CURRENT
The power supplied to a 50mH inductor from a 120V, 60Hz source will be
Whats the difference btwn a latch, port,data bus buffer? Do they all not hold data in d flip flops??
How to synchronization will be done between two DGs ?
what is a synchronizing lamp ?
what could be the RMS value and average value of a 4 phase sine wave?
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
why genarator genarating voltage 11 KV?
block diagram of 2 ups system connected in parallel mode?
what about GD square and its important for motor design?
