Interested to Buy Any Domain ? << Click Here >> for more details...
A differential pressure transmitter is configured to measure the height of an open tank : height 10m and dia 5m.
Suppose this same transmitter is shifted to another open tank : height 10m and dia 4m.
What will be the %error in measurement? how?
- 3 Answers
- 4799 Views
- McCoy Engineering, I also Faced
- E-Mail Answers
Answer Posted / mukesh dayama
Zero error because of both tank height same
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
How to Calibrate Flow Switch in field
What is the diffrence between ff tx and non ff tx
Specify ideal accuracy of flow element like orifice plate, Ventury, Annubar. Ultrasonic flow meter etc.
How many ohms are required for proper earthing?
whatis range of marcury filled tempereture gague
how many types of preheaters are in cement industry & what r they can any body explain?
What is stripper & spilitter ? Diffrence in this.?
Difference between 2-Valve Manifolds, 3-Valve Manifolds and 5-Valve Manifolds 3 with diagram
Draw a great bridge circuit.
what is span value and zero ? and how set ?
With N nodes and B branches what will have a network ???
how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744
How to Calibrate Vibration Probe (Axial, Redial) in field
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Explain working principle of lvdt?
