Interested to Buy Any Domain ? << Click Here >> for more details...
why we use carbon brush in exciter&genrator?
- 5 Answers
- 11723 Views
- ABB, SMC, I also Faced
- E-Mail Answers
Answer Posted / hemanshu
beacause carbon contact resistance is too low 0.7 ohm. so its use for exitation of motor & generator.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
What current position are you holding in your current company?
ho can we calculate the conductor insulation value according to their ratings like voltage,current etc.how insulation value related with voltage,current and power of amachine
When we need up only in o/p 440v, so why we use directly in 11kva in input?
sir& friends i want the collection of recent quetions asked in interview of top most companies please send me on my email san.jsr@hotmail.com
How to measure the earth resistance value in a concrete pavement(flood light area)?
how to test and calculat the head and discharge in borewell compressor
Why is back emf used for a DC motor? Highlight its significance.
what is vA rating and class of a ct.
what is a synchronizing lamp ?
what parameters should we check to reduce the power bill
What is a compensator?
What is difference is of VSD,VFD,VSDS, are they the same as the direct current to control dc using above mention
Transmission through a short line depends on
is there any device that works properly accept relay, it may be fuse but if i want fuse of 33kv 300 amp it is avaliable, pls give me details
