Answer Posted / shashikanta sahoo(kumar linku)
A device who helps machine-parts to trun smoothly
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
How to exite natural frequencies in a overhung rotor
When effect of variations in specific heats is considered then how do maximum temperature and pressure vary compared to air standard cycle ?
What is the microstructure content of D25-8 nodular cast iron?
What do you do to prevent flare black?
Explain in an orderly manner how the force in the member of a truss be detected using the method of joint.
What will happen if head of a selected pump is not utilized in a closed loop water circuit? Flow will increase or decrease or remain same?
What is the difference between an electric motor and an electric generator?
Where pneumatic system is used?
Which rays are produced by cobalt-60 in industrial radiography ?
What are the important operational performance parameters in design of fuel firing equipment ?
Explain the difference between hydraulic oil and engine oil?
why we use kg/cm2 instead of kg/m2 as a unit of pressure. As we know kg is a MKS unit and cm is a CGS unit. So why we use combination of both(kg/cm2)while describing the pressure.
What is difference between ASME EN & IS related welding procedures(WPS/PQR/WPQ)
What is the date of first titan launch from cape canaveral?
Action plan to closr NCR (NON COONFORMANCE REPORTS)