Interested to Buy Any Domain ? << Click Here >> for more details...
Can someone explain how does an IDMT relay works.
- 1 Answers
- 3142 Views
- AFM, I also Faced
- E-Mail Answers
Answer Posted / poorvalingam
Its also called inverse relay. consider disk type induction relay. you set the over current setting 70% means this disk will pickup above this setting.consider if 85% of load going the disk will rotate and trip the circuit. if the load is 110% that time the disk operate very soon then previous case, it trip very quickly.
The operating time inversely proportional to the fault current this type relay called Inverse Definite Minimum Time Lag relay (IDMT)
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Proviiding the Dedicated N earth and individual Body Earths ,Finally these all looped /Now my Question :- will it not harm in case of Transformer Fault current flows in Dediacted N Earthing to Looped Body Earthing.
What is Auto Mains Failure Panel & Auto Synchronizing Panel
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
ht side line to earth voltage
how to ctrl motor by use of ac or dc drive.plz explain evdintly
An ISP is granted a block of addresses starting with 150.80.0.0/16. The ISP wants to distribute these blocks to 2600 customers as follows. a) 200 medium size businesses; each needs 16 addresses b) 400 small businesses; each needs 8 addresses c) 2000 households; each needs 4 addresses Design the subblocks and give the slash notation for each subblock. Find out how many addresses are still available after these allocations.
what is the size of ht cable of 33kv ht line and transformers ratings are 1 Mva and 5mva.please send formula also.
standard earthing rating for power line..
What are the commonly used schemes for the bus zone protection?
what is EIB lighting control system? what is the advantages of this system?
How dia computation perfomed in cold rolling mills .
what are the disadvantages in GIS over AIS
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
distribution is maximum done by a)radial b)network c) parallel d)b & c
when ID fan will immediately stop through VFD what exactly cause and problem the ID fan
