Interested to Buy Any Domain ? << Click Here >> for more details...
What is purpose of APFC panel?
- 7 Answers
- 10697 Views
- Techno Electric and Engineering, I also Faced
- E-Mail Answers
Answer Posted / manjunadh
apfc means automatic power factor control.....it is used to improve the power factor it is a relay
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
why on delay timer used for fully automatic star delta starter?
How to check the cable fault / hv test of transformer cable.
Refernce currents are to be generated using refernce cueernts how can this be done
What is BusBar integrity test and how it is conducted?
What is MS-EXCELL?
how oil in the MOCB was reduced compared with OCB? what are the features of the MOCB?
sir i completed apprentice in TNEB.apprentice is eligible for 'c' licence
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
what is the standard duration after failure EB power
Why does an induction generator is preffered as compared to synchronous generator in especially a wind energy power production project?
how to failure indution motor insulation & how to improve heat in motor insulation
IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?
what is the difference betweem star connected motor & delta connected motor?
on a three-winding transformer relationship delta-delta-star, on third winding why the relationship is a star? what are the advantages and disadvantages? Thank you and please help
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
