Interested to Buy Any Domain ? << Click Here >> for more details...
If the secondary winding will be open in current transformer, how to damage the insulators
- 2 Answers
- 3765 Views
- TPDDL, I also Faced
- E-Mail Answers
Answer Posted / suhel
If sec open., the flux become zero.so a high voltage induced in sec winding and the insulation damaged
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
How to calculate the no of Ceiling fan (1200mm sweep) per unit area?
what happen if drive input fail momentry at 48.5 HZ frequency?
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB Machines of higher rating?
what is a bus riser in power system and why it is used
Hello sir i m student of gtu .what is idp.
What are Contactors? How they works and what its highest rating?
In electrical what is earth(ground)connection, wht is the importance of it, why it is recomended to maitain below 3VAC between Neutral and earthspecially in PLC used machines?
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
If UG power cable both ends are to be earthed or what? If not why?
What are test signals and their significance?
R=*ΒΆ l/a
how pt is using
