Interested to Buy Any Domain ? << Click Here >> for more details...
conditions for parallel operation of dc generators
- 4 Answers
- 13674 Views
- I also Faced
- E-Mail Answers
Answer Posted / shamsher singh
Dc dg not generate the frequency and phase sequence it will generate the plus and negative and need the same capacity
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what is transformor oil gread
What is a surge supressor why its is used in synchronous generators
Why is it prefer to initiate circuit breaker failure by "86" lockout relay not by "94" tripping relay ?!
Define early construction of human being
The efficiency of a 100kva transformer is 0.98 at full load as well as half load , for this transformer what is the Copper loss at full load ?
At the starting of dc motor and syn.motor and induction motor high current flowing through the winding. Due to this the windings burnt out. To avoid this different types of starters are used. But incase of transformer what Will be used (At starting no emf is induced in the primary winding)?
how to find the Motor,s insulation Power?
What is meant by load angle of an alternator? Upon what factors does the load angle depend?
If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
how to get electrical supervisor competency certificate in gujarat. i did 3 year diploma in electrical
Greeting to all members, How to calculate spill current when we have different ratio CT and Class for REF(Low Imp) I have 500/1A 5P20 @line side n 400/1A CL.X @ Neutral.
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
What we mean by vintage of an engine+Generator?
