How to initialize 20,000 bytes in the Assembler..
- 5 Answers
- 16333 Views
- Amdocs, IBM, I also Faced
- E-Mail Answers
Answer Posted / slantt
How about using a 'getmain' for the storage amount? I believe the macro has the capability to set the requested storage to x'00'. Don't forget the 'freemain' if you're done with the storage but not the program. The storage will be freed during program close.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is house keeping in assembler?
Explain the difference in data type "x" and "p"?
what is need of start 0? In steed of
In the house keeping section of an MVS assembly language program, like the one below STM R14,R12,12(R13) BASR R12,R0 USING *,R12,R11 LA R11,2048 LA R11,2048(R11,R12) .... .... 1. What if BASR R12,R0 IS NOT PRECEDE USING *,R12,R11? 2. USING (base address), REGISTER does USING directive says assembler to treat particular Register as a base register with the mentioned base address..in the above case * i.e current location counter..well if that is the case why we need BASR R12,R0 ? 3. What if I write like STM R14,R12,12(R13) BASR R12,R0 LA R11,2048 LA R11,2048(R11,R12) USING *,R12,R11 there is no address resolution being calculated in both LA statements so is it a right way to set Base register?..will there be any issues with Domain regarding R11 and R12?
Explain how to access vsam file?
how do you round the addition or subtraction of two numbers in assembler? what does the following code do? change process tool(code changes from dev to prd) the changes made to your code should be effected in live. How the process takes place. That is how can you move the code changes from development to production?
How do you round the addition or subtraction of two numbers in assembler?
Explain about house keeping in assembler?
What is need of start 0? In steed of can we use anyother numerics? If we use what will happen?
What does the following code do? Ap wkur,=p5 where wkur is a label?
Explain how to pass instream data in sysin with assembler?
How to pass the parameters from jcl to assembler program?
What does "using" do?
How is data passed from a calling program to an assembler called program?
What will happen if we drop the base register in the program which contains only one basereg?
