Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / raman
Voltage step up or step down by using a transformer on same frequency.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is size of 3phase 4wire cable to be used for 11 ton ductable A.C and how to calculate cable size for different load
Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
how to maintain frenquncy with syncronising sub-station for distribution
i want design of D.C.MOTOR 1HP 960RPM AND 2HP 960RPM ITS URRGENT
how you will decide the distance between the power transformer and its fencing
What is EHT tariff or Power factor Tariff ????
how we select ac fuse rating of an power inverter???
How can we findout the maximum efficiancy of Transformer? At which load?
The power factor of the fixed load is 0.8, now the p.f is varying from 0.8 to 0.5.
Dear Respected sir how to test ABB REX521 protection relay by relay tester.
How to calculate capacitor bank size at a load 800kVA.
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
in what type of applications v can use q meter?
Please define ohm’s law for a.c (alternating current)?
