Answer Posted / saumya ranjan senapati

1/0.230*0.115*0.075=?cum
then cum*35.28=cu ft

Can inverted beams used in pipes during construction?

1385

---

what is the exact dia of 8swg and 10swg gabion wire

2364

---

Which is the most prominent tower of world?

1142

---

How much quantity of cement and sand required for the inlining of 610mm dia MS pipe 8.7mm thk.Inlining thickness is 10mm and CM ratio is 1:1.5.

4245

---

How did the romans get water up hills using aqua ducts?

1352

---

How to design staircase.plz tell me formula for the design the staircase.

2042

---

rimmer in pile foundation

2965

---

Can compresive strength test for concrete at 1 day age possible to carry out? If yes, which IS code describes the procedure for such testing?

2128

---

how find the cut length of tringular ring and any formula find out the quantity of circular brick work

6498

---

what is pqc

1820

---

how many numbers of 4inch bricks and get consumed in 9 inch BB masonary wall in cubic feet.plz send my below e.mail adress

1892

---

What is the cost of shuttering per Sqm.? How it is calculate by thumb rule...?

2090

---

The largest size of paper used in plotter to print the drawing made by Autocad .

1911

---

Why steel rods are produced only in even dimensions?

2690

---

With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr

2499

---