What are the cable come out from the paddle type flow sensor.and how is further connections
- 1 Answers
- 2156 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajesh.
Paddle type flow sensor is designed to work on 6 – 24v dc voltage, the connection cable from sensor color code is:
White: signal.
Red: +6 – 24 vdc.
Black: -ve.
Further connection is made supply for sensor 12 vdc give on red (+) and black (-) wire, and measure signal on red (+) and white.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.
how to measure draft pressure in transmitter pl. give its single line digram
how to connect transmitter measuring sulfur process? 1-by using long impulse line or 2- by using coated short impulse line
How is automatic reference junction compensation carried out in temperature recorders?
What is the use of double seated valve?
can you send remote seal interface level transmitter calculation steps for oil water saperator.
How a conductivity sensor & analyzer work at boiler, whats the principle & science is beyond this,How conductivity sensor sence & convert signal & move toward analyzer & analyzer show reading in percent? also what is temperature compensate option in conductivity analyzer
SOME OF YOUR QUESTIONS ARE NOT MAKING ANY SENSE SO TRY AND PUT IN A LITTLE BIT MORE EFFORT BEFORE YOU POST A QUESTION. WE WILL ONLY HELP THOSE WHO WE CAN SEE ARE TRYING TO HELP THEMSELVES.
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
I installed the smartplant instrument v8, but can not be opened, that always said: "INTools 2007 hardlock no found". So Could you help me how to do for that?
Is there any relation between Artificial Intelligence and Instrumentation?
how to commission furnace ( water heater)
what is the calibration procedure for magnetic flow meter @ onsite
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
Sir, I am working as a Instrument Engineer in Grasim Industries. Can any body provide question answer for interview purpose
