Interested to Buy Any Domain ? << Click Here >> for more details...
what happens if sf6ckt breaker gas pressure is high or low about the actual rating of gas pressure(5kg/cm2)
- 2 Answers
- 3685 Views
- I also Faced
- E-Mail Answers
Answer Posted / ashish sahebrao tekade
If there is a low pressure the arc quenching time of current is low, thats why relay got large time to operate. If there is high pressure of sf6 gas there is a possibility to break a bottle of sf6 gas filled which is harmful of machinery
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
how many types of motor can be used in washing machine
how to interlock 3 nos MCCBs using under voltage coil. please provide me circuit diagram?
sir my exam is on 19/6/2013 under electrical branch pls send me sample aptitude questions as well as sample technical questions for jindal steel and power company
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
How to decide DO set rating of Transformer?
Whether IP65 enclosure box blocks ventilation if driver for LED have to enclosed inside IP65 box
where is the need for short circuit test for 3 see is required and why? can you explain in brief with application
does the Trivector Meter of three phase automatically takes care of the low power factor and gives the reading accordigly or it does not take care of the Power factor while giving the readings please explain
Can anybody please refer the best and simple book for about Protection relays and in detail of all its protection ?
how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
what could be the RMS value and average value of a 4 phase sine wave?
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
How to configure the drives in PLC, through Profibus commnication. And to how to address it?
all interview questions with answers of ntpc (2000-2009
