Answer Posted / pardeep kumar
Daily because
Whan the run dg
checking running hours reading
Coolant oil level and diesel proper way daily check
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
can we conduct the swineburne's test on a dc series motor? why?
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
what are all the components required to assemble solar panel other than pv cell?
what is deffrence between squirral cage and wound rotor in IM?
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
what is under coal gassification?
Dear sir, By which formula u can calculate for a particular kv line there is a range of mw.
sir please send me techinical questions for junior engineer posting in bangalore railway i am diploma holder
-What should be minimum value of insulation resistance and maximum value of earth resistance at any electrical instillation and what is method of testing the same.
what is automatic voltage regulator?we can control the vlotage by using fuzzy controller in matlab?why we go for fuzzy?
explain the process of commutation in a dc machine. Explain what are inter-poles and why they are required in a dc machine.
Give idea about General Engineering. From which book i can study this topic. Pl. reply me via email. My email is ravi@bhelhwr.co.in, also give the name of book/website, from where i can prepare it.
What are the advantages of a three-phase system over a single-phase system?
Can we put 3 layers of cable tray while installing tray
what is the meaning of neutral displacement ???