Interested to Buy Any Domain ? << Click Here >> for more details...
For Bus duct hi pot test, where we want to connect the return and ground leads?
- 2 Answers
- 4804 Views
- I also Faced
- E-Mail Answers
Answer Posted / mohd fazil
the more specific Hot Hipot test can bring about feelings of apprehension. Yet the concepts involved ... peak (maximum) voltage is what we are concerned with. ... Connect the return lead of the Hipot tester to the metal chassis or enclosure of a ... transformer is used to isolate the input power to the DUT from earth ground.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
After doubling voltage from solar cells & use step down voltage transformer can we get high current output with low voltage.
WHAT IS SUBSTATION & ACCORDING TO VOLTAGE HT,EHT SUBSTATION EXPLAIN IT
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
What is the height of DA, DAL, DB, DC & DDE tower?
Why are the cores of large transformers built up of circular transactions ?
what is static frequency converter?what is the function...of sfc...?
how we sesign the transformer give some specifion regarding design of transformers
What is the effect of pi controller on the system performance?
What is VSCF windelectrical system?
Explain and give me an example of a time when you had to explain some new procedures to your co-workers for quality service delivery, how did you go about it?
Comparision of Air break circuit breaker, SF6 Circuit breaker and vacuum circuit breaker.
What is the permissable nutral current of three phase system as per IS standards?
we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Distribution transformer we provided 2 separate earthing pit for Body and 2 separate earthing pit for neutral,we can not connect separate body earthing pit to other earthing pit but we do metal glanding in secondary side cable termination in both side, transformer and PCC panel (LT Panel), is this safe for transformer and other equipment?
