Why the ceiling fan has three blades, why not two,four or
five?
- 4 Answers
- 16868 Views
- I also Faced
- E-Mail Answers
Answer Posted / rishi barnawal
Best compromise is achieved by choosing 3 blades between equilibrium, cost and weight of fan.
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
what is mppt (maximum power point tracking ) and how they used in solar power generation ??? what are the main components used in mppt?????
How do the synchronizing lamps indicate the correctness of phase sequence between existing and incoming alternators?
either water sensor or flow meter,how we observe the water level, f any other equipment are in market ?
What is transformation ratio what it describes?
Why front mounted CT polarities are always towards breaker?
Explain the operation of grid connected central solar inverter ?
Draw a SLD for main panel for school having connected load of 1200kw and emergency generator 200kw.also show the increase of additional load of chiller 225kw in the lv panel indicating meter postion size of transformer ,cables and capacitor bank.
How to control motor gearbox speed and friquency? If length of cable and dia given, how to measure the voltage drop?
is ac supply can store
list the type of vfd? wich is sutable for heating kiln?
what material is used in capaciter
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
Difference between a pilot wire and a normal conductor?
What is inrush current?
