Interested to Buy Any Domain ? << Click Here >> for more details...
What is difference between sensors and transducers?
- 2 Answers
- 4793 Views
- I also Faced
- E-Mail Answers
Answer Posted / vikas
sensor working only sense and transducer working sense and convert signal mech to electrical.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
What are the application of bernoulli’s theorem?
How to erection of DCS Panel at site step by step
How to calibration coriolis flow meter?
What is PDS and PDMS ?
How does your previous experience relate to the job you are applying for ?
what is the PC interface and software for connection to ABB logic module “ LM011-CE18RAC “ ( for Programming ) ??
The company where I am working, their is rosemount 5400 series radar type level transmitter, it is meant to show level of filled tank, but along with the level it is showing temperature also, so my question is how a onon-contact type radar type level transmitter can show temperature even if it does not have any contact with the fluid?
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
what is RTV function in in process control?
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
Difference between 2-Valve Manifolds, 3-Valve Manifolds and 5-Valve Manifolds 3 with diagram
Can any body tell me about SAP MAINTINANCE MODULE. WHAT IS its function and application. And study material Source about it. I shall be very thankful.
any questions on motor and energy conversions machines?
a flow transmitter [range-0-400mbar] connected in process line. please explain me how to calibrate the flow transmitter , & how to do static error
